磷钨酸插层锌钛水滑石的制备及催化脂肪酸甲酯环氧化反应
DOI:
CSTR:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

江苏省2013大学生实践创新训练计划省级重点项目(201310291041Z)


Epoxidation of Fatty Acid Methyl Ester over Phosphotungstic Acid Pillared Zn-Ti Hydrotalcites
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    采用离子交换法制备了一系列磷钨酸根插层Zn-Ti水滑石,利用XRD、FT-IR、SEM对所制催化剂进行了表征。结果表明,磷钨酸根插层锌钛水滑石后仍保持原有的骨架结构。用制备的类水滑石催化脂肪酸甲酯环氧化反应,考察了所制催化剂的催化性能。当n(过氧化氢):n(原料双键)=1.5:1,催化剂用量为脂肪酸甲酯质量的7.0%,在70 ℃下反应7 h时,脂肪酸甲酯转化率可达90.6%,环氧化产物选择性可达86.0%,优于Zn-Ti水滑石,其对脂肪酸甲酯环氧化反应显示出较高的催化活性。插层水滑石重复使用5次后,催化性能仍较稳定。

    Abstract:

    A series of phosphotungstic acid pillared Zn-Ti hydrotalcites(LDHs) were prepared by using the ion-exchange method. The structures of samples were characterized by XRD、FT-IR、SEM. The results showed that no significant structural change of LDH was observed after intercalation. The epoxidation of fatty acid methyl ester reactions were carried out over the catalyst samples. It was found that, 90.6% conversion of fatty acid methyl ester and 86.0% selectivity to epoxidation product could be obtained at the reaction temperature 70 ℃, reaction time 7 h, n(H2O2):n(double bond)=1.5:1, and catalyst dosage 7.0% (based on the weight of fatty acid methyl ester). The catalytic performance of phosphotungstic acid pillared Zn-Ti hydrotalcites was better than that of Zn-Ti LDH respectively. The novel phosphotungstic acid pillared Zn-Ti hydrotalcites catalysts revealed good catalytic performances to epoxidation of fatty acid methyl ester reactions. Furthermore, the pillared hydrotalcites showed a good repeatability after 5 times reuse.

    参考文献
    相似文献
    引证文献
引用本文

孙守飞,丁云,杨欢,邹畅畅,屈秀红,任晓乾,武文良.磷钨酸插层锌钛水滑石的制备及催化脂肪酸甲酯环氧化反应[J].精细化工,2014,31(5):

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2014-01-06
  • 最后修改日期:2014-03-06
  • 录用日期:2014-03-11
  • 在线发布日期: 2014-05-04
  • 出版日期:
文章二维码